DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Electrical and Wiring > garage heater install




Reply
 
Thread Tools Search this Thread Display Modes
Old 01-08-2012, 09:33 PM  
brand_1525
Junior Member
registry_dropdown_25269_66069
 
Join Date: Jan 2012
Posts: 7
Default garage heater install

I have recently purchased a garage 5000watt 240 volt heater from farm and fleet. It is calling for a 10-3 wire which I bought, I hooked the wiring up to the heater ran the wiring to the outlet about 25 ft. To the 220 outlet put a male end on it plugged it in turned it on and nothing! Anyone have any clue what may be wrong?


brand_1525 is offline  
 
Reply With Quote
Old 01-09-2012, 06:46 AM  
JoeD
Contractor
registry_dropdown_728_66079
 
Join Date: Mar 2006
Location: Welland, Ontario
Posts: 1,060
Liked 125 Times on 101 Posts
Likes Given: 4

Default

How did you connect into the panel? Did you use a full size double pole 240 volt breaker?
What type of panel do you have? Some panels the breaker can be installed such that you don't get 240 volts.


JoeD is offline  
 
Reply With Quote
Old 01-09-2012, 07:46 AM  
kok328
Supporting Member
HRT_SUPPORTER.png
registry_dropdown_4883_66082
 
Join Date: Nov 2007
Location: Grand Blanc, MI
Posts: 2,315
Liked 144 Times on 122 Posts
Likes Given: 71

Default

Anyone have any clue what may be wrong?

1) Wires might be disconnected between the breaker panel and the oultet.
2) Breaker may not be turned on.
3) Wired incorrectly.
4) Heater is bad right out of the box.
kok328 is offline  
 
Reply With Quote
Old 01-10-2012, 05:56 AM  
brand_1525
Junior Member
registry_dropdown_25269_66112
 
Join Date: Jan 2012
Posts: 7
Default

I checked the outlet it is putting out 240v and everything is wired right, when I plugged it in again and turned it on the fan turned on and very heat started to come out but it was not blowing it out! I have about 25ft of the #10 wire going from the heater to 240 plug that I am plugging it into, does that have anything to do with the heat not blowing out?
brand_1525 is offline  
 
Reply With Quote
Old 01-10-2012, 04:17 PM  
kok328
Supporting Member
HRT_SUPPORTER.png
registry_dropdown_4883_66140
 
Join Date: Nov 2007
Location: Grand Blanc, MI
Posts: 2,315
Liked 144 Times on 122 Posts
Likes Given: 71

Default

Fan turned on and heat started coming out but, it was not blowing out?
What is the fan blowing?
As long as your getting power to the unit, the cord & plug would have nothing to do with the furnace not operating correctly.
kok328 is offline  
 
Reply With Quote
Old 01-11-2012, 09:08 PM  
brand_1525
Junior Member
registry_dropdown_25269_66196
 
Join Date: Jan 2012
Posts: 7
Default

I can feel the heat coming out but it is not blowing like a heater does, fan runs but it just is not blowing the heat out. Not even when it is on high
brand_1525 is offline  
 
Reply With Quote
Old 01-12-2012, 06:32 AM  
JoeD
Contractor
registry_dropdown_728_66224
 
Join Date: Mar 2006
Location: Welland, Ontario
Posts: 1,060
Liked 125 Times on 101 Posts
Likes Given: 4

Default

Open the heater and measure the voltage inside. It almost sounds like you have it connected to 120 volts instead of 240 volts.
JoeD is offline  
 
Reply With Quote
Old 01-20-2012, 05:26 PM  
donald73d
Junior Member
registry_dropdown_23744_66740
 
Join Date: Sep 2011
Location: Canaan, New York
Posts: 28
Liked 1 Times on 1 Posts

Default

It called for 10-3 wire? Is that 3 wires & ground? Some 220V devices with a fan, timer or light, want a neutral so they can run one small part on 110V and the rest on 220V. Is the outlet a 3 prong or 4?

An oven should not power the oven light with hot to ground for 110V it should be hot to neutral.
donald73d is offline  
 
Reply With Quote
Old 01-21-2012, 04:45 AM  
brand_1525
Junior Member
registry_dropdown_25269_66765
 
Join Date: Jan 2012
Posts: 7
Default

Yes the wire is 10/3. Green, white, and black. And the plug is 3 prong plug.
brand_1525 is offline  
 
Reply With Quote
Old 01-21-2012, 04:46 AM  
brand_1525
Junior Member
registry_dropdown_25269_66766
 
Join Date: Jan 2012
Posts: 7
Default

I mean the outlet is a 3 pronge


brand_1525 is offline  
 
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Install Gas Water Heater cibula11 Plumbing Forum 10 05-30-2011 10:57 AM
Garage ceiling for garage remodel dexterdog Walls and Ceilings 7 03-05-2010 12:34 PM
Adding an electric garage heater scottman1027 Electrical and Wiring 16 10-05-2009 11:16 PM
5000 Watt Heater In Garage? Maladaahn Electrical and Wiring 3 01-30-2009 03:45 PM
New Dishwasher Install tooltime Plumbing Forum 7 08-23-2006 10:19 PM

Newest Threads

LATEST SPONSOR DEALS