Connecting Knob and Tube to Junction Box
I just finished replace an old ceiling lamp. House has mostly knob and tube, and knob and tube serviced the ceiling lamp. I wanted to know if there is a proper way to make the splice between fixture and knob and tube. There was no junction box, so I installed one. Any kind of wiring entering a junction box has some fitting that secures the wiring to the box. But I cant find any fitting suitable for knob and tube. I popped two of the smaller knock outs and installed a rubber grommet for each. The knob and tube wiring has the heavier insulation from the knob to the fixture. But the wire is clearly loose as it enters the box. The securing knobs are only a foot from the fixture, and it is all inside the space between the ceiling plaster and the floor boards above the ceiling. So it shouldnt get disturbed. But I wondered if there is a proper way to put knob and tube into a junction box.
Yeah, one day I will rewire everything. But this lamp needed replacing before I could run a new up to code circuit.
And just an aside, there was a gas pipe running to the same spot at the lamp. What was weird is this is a 1920s house. They must have wired both the knob and tube and the gas pipe before they plastered over the ceiling. Why they ran both gas and electricity to the spot for the lamp escapes me.
Thanks in advance.