DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Carpentry and Woodworking > New cabinets with a chalky finish

Thread Tools Search this Thread Display Modes
Old 03-13-2007, 03:44 PM  
Junior Member
Join Date: Mar 2007
Posts: 4
Default New cabinets with a chalky finish

We just had a new house built and new Dynasty/Omega cabinets made of quartersawn oak installed in the kitchen. The finish on the cabinets is a matte finish, and doesn't have to my knowledge any urethane or lacquer. It definitely isn't glossy. The builder decided to clean the cabinets before we moved in and used (he says) Liquid Gold. Now the cabinets have a chalky look and streaks are also visible. They have tried to take off the coating with mineral spirits, but the best look so far is a dull look with minimum streaking. We are holding off treating all of the cabinets until they get a few doors to look good. We had a drawer front replaced for other reasons and the difference is noticeable always, drastic in the right light. An antique restorer we know was just over and told us the finish is ruined. I am looking for advice. I am sure our builder is too.

x37green is offline  
Reply With Quote
Old 03-14-2007, 02:51 PM  
Square Eye
Senior Member
Square Eye's Avatar
Join Date: Jan 2006
Posts: 1,273
Liked 6 Times on 5 Posts


Copied directly from the website;
We achieve the richness of a fine furniture finish by sanding and staining each piece by hand. Oven-cured to catalyze the top coat, our finishes enhance the wood grain and protect the surface. Omega Armor finishes wipe clean with a damp cloth and require no special care.

Usually this means they don't want you using harsh cleaners.

Very possible the finish could be ruined. A high quality wood polish/wax (not Glade, maybe Briwax, Formby's, Deft or similar brand paste wax) would be my next step unless the cabinets are a glazed finish.

Glazed finishes are unique and must be cared for as the manufacturer recommends. It doesn't take much rubbing to ruin a glazed finish with the wrong product.

Call the manufacturer now and get specific information on what to use.

[URL=""][size=3]The Ten Commandments of House Repair Talk[/size][/URL]

[URL=""]Square Eye's home page[/URL]
Square Eye is offline  
Reply With Quote
Old 03-15-2007, 02:32 PM  
Junior Member
Join Date: Mar 2007
Posts: 4

Thanks for the info... We had already contacted the manufacturer. They referred it back to the supplier who referred it back to the builder. The builder's rep was here with the manufacturer's rep today. They tried to convince my wife they could do the job with mineral spirits, in spite of the fact that is hasn't worked yet.

No, they are not glazed. We have a cabinet maker coming by tomorrow to look and give us yet another opinion. Then the builder will try the mineral spirits again on a door that he will pick up Monday. I will ask him about the cleaners you mentioned.
x37green is offline  
Reply With Quote
Old 03-30-2007, 12:32 PM  
The Cable Guy
Join Date: Mar 2007
Posts: 48
Send a message via Yahoo to AndyD5

I am assuming this is just the doors and drawer fronts you're talking about and not the face frame of the cabinet if so just make the builder give you knew doors and drawer fronts that match undamaged it was new you shouldn't be forced to live with what I would consider now covered up mistakes on something new!
-Andy the cable guy

I love to work on my house would love to help you with yours!
AndyD5 is offline  
Reply With Quote
Old 07-16-2007, 09:50 AM  
Proven Editor
Junior Member
Join Date: Jul 2007
Posts: 1

I agree with AndyD5! You should NOT have to live with mistakes.
Personally, I would never use less than the best for kitchen or bath. Water is a potential problem in those areas.

If you want to give the builder an easy permanent technique, he is welcome to vist my finishing tips

Good luck, Jim
Proven Editor is offline  
Reply With Quote
Old 07-26-2007, 03:18 AM  
Senior Member
Join Date: Oct 2006
Posts: 119

It's up to the builder to make it right. If this means new cabinets, so be it. Urrgh, see so much not done right here. Sore point with me.
Rustedbird is offline  
Reply With Quote
Old 12-03-2007, 07:25 PM  
Junior Member
Join Date: Mar 2007
Posts: 4
Default That's what I thought

Thanks for the words of support.

Unfortunately, this one is going to lawyers. I could probably pay for repairs myself for less than the cost of legal proceedings, but there is a point to prove. Besides, the cabinets cost $18,000 and if I have to pay, I hope to make the builder pay as well.
x37green is offline  
Reply With Quote
Old 12-04-2007, 01:15 AM  
Senior Member
ToolGuy's Avatar
Join Date: Nov 2007
Posts: 482
Liked 1 Times on 1 Posts


I'm not sure but doesn't Liquid Gold contain a high amount of silicone? If so, the silicone gets into the very finest pores and microscopic cracks in the finish and soaks into the wood. If this is the case I'm afraid there is no fix except to remove the finish completely, clean the wood, then do a new finish.

I'll leave legal proceedings to the lawers.

[COLOR="DarkRed"][B]~ ToolGuy ~[/B][/COLOR]

[I]Save money on tools at [URL=""][/URL]
ToolGuy is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
fiberglass finish fiasco daniel2229 Windows and Doors 4 12-08-2012 01:26 PM
Kitchen Cabinets shan2themax General Home Improvement Discussion 11 03-16-2010 03:02 PM
Can I install cabinets over Laminate flooring? Fat B Flooring 3 01-26-2007 06:37 AM
Self build customs.. or off the shelf cabinets? tooltime Carpentry and Woodworking 1 09-16-2006 10:58 AM
Kitchen vinyl under cabinets audaceblue Flooring 2 06-27-2006 01:56 AM

Newest Threads