DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Electrical and Wiring > Motion Sensor and exhaust fan




Reply
 
Thread Tools Search this Thread Display Modes
Old 08-01-2009, 05:14 AM  
Nabu the Wise
Junior Member
 
Join Date: Aug 2009
Posts: 1
Default Motion Sensor and exhaust fan

Hello everyone, and thanks for listening to my question.

In a corner closet in my home, I had an exhaust fan installed (just a bathroom fan) connected to a three way switch, with one switch inside the closet, and the other outside. The handyman who installed it wasn't sure what sort of motion sensor should be installed (my ultimate goal) so he simply installed switches with the idea of replacing them later. The idea was to use this closet for the cat litter location for our cats (my wife loves her cats, but can't stand the cat litter smell that comes along with them).

I later installed the motion sensor inside the closet so it would detect a cat going into the closet, and kick on the fan for the duration of the timer. Overall, it worked rather well, except I didn't get a motion sensor that was intended to run anything other than lighting and I believe this caused the fan (and possibly the motion sensor) to fail after a year.

Right now, I'm merely speculating that this is what actually happened, but the motion sensor (a Heath / Zenith SL-6107) has a switch that basically bypasses the motion sensor and makes it a standard switch, switched to on, and it's still not turning on the fan. The switch specs state that it can run a 1/8 hp fan, but all of the instructions talk about lighting, so I question how much the system was actually intended to run a fan. (When the switch ran the fan, it was obvious that it wasn't running at full power. The tone of the fan changed when the motion sensor was running the fan and when the switch was set to run as a regular switch).

Since I likely need to replace the fan and switch, I'm looking for advice on what might make a good combination for this setup. I'm not really sure about the specs of the fan, but it seemed to be almost too strong. (Not that that was much of a problem, but in my mind the fan doesn't need to suck too much AC or Heat out along with the air, it just needs to create enough negative pressure that the smell goes out with the air) Also, the motion sensor worked fairly well, but I wasn't convinced that it really did that good a job running the fan, and the timer was a little short in my opinion (it ran for about 20 minutes). Ideally, I want a fan that was either variable speed, or just fairly weak, and a motion sensor that had a 45 minute timer.

Has anyone here set up something similar (or just a standard bathroom fan setup)? What parts worked well for you?

Thanks everyone,

Bill



__________________
Nabu the Wise is offline  
 
Reply With Quote Quick reply to this message
Old 08-01-2009, 07:02 AM  
locknut
Member
 
Join Date: Apr 2009
Posts: 75
Default

Bill: If a motion sensor switch is not suited for control of a fan motor, you can isolate the switch from the motor by means of a relay. The motion sensor switch would activate the relay coil only. The relay contacts would do the work of switching over the power to the fan. It may be that the sensor device was affected by the relatively high inductance of the fan motor. A relay has a value of inductance, but much less than the motor. The relay would serve as a motor starter and substantially reduce the starting load through the sensor switch.

__________________

Last edited by locknut; 08-01-2009 at 07:22 AM.
locknut is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Photo sensor landscape light brasilmom Electrical and Wiring 3 02-10-2009 06:34 PM
Exhaust Fan For Bathroom AMI_1575 General Home Improvement Discussion 11 09-29-2008 08:22 PM
Motion Sensor Rincon Electrical and Wiring 5 06-11-2008 04:11 PM
solar powered motion-sensor outdoor light todd_k Electrical and Wiring 3 01-19-2007 04:13 PM
Sensor Switch Radioman Electrical and Wiring 19 11-27-2006 06:35 PM

Newest Threads

LATEST SPONSOR DEALS