DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Windows and Doors > casing a problem door

Help Support House Repair Talk by donating using the link above.
Thread Tools Search this Thread
Old 02-14-2010, 12:50 PM  
Junior Member
Join Date: Feb 2010
Posts: 1
Default casing a problem door

I have installed a new door and the right hand jamb is tight against an inside corner so there is no room for casing. Should i put the trim on the perpendicular wall or leave it off or ?? i could cut down a piece, but all of the other doors are cased with 3.5 inch trim and i only have room for 1 inch on the right hand side.

Any suggestions would be appreciated.

kevinb is offline  
Reply With Quote
Old 02-14-2010, 09:35 PM  
door guy 4 ya
Join Date: Feb 2010
Posts: 27

Use a table saw and rip the trim down to where you can mount it with mitering the corners for a finished look.
Doorguy4ya is offline  
Reply With Quote
Old 02-16-2010, 02:40 PM  
Junior Member
Join Date: Feb 2010
Posts: 2

Ripping down the trim on a table saw is the only way to have it look good
Thank You
doors2fit is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
interior door problem 1989gta Windows and Doors 3 02-14-2010 09:36 PM
Interior door problem bsmutz Windows and Doors 1 08-15-2009 01:57 PM
Garage Door Opener problem generic703 Windows and Doors 6 01-14-2009 10:35 PM
Shower door frame problem jgalt Windows and Doors 1 01-02-2009 10:53 PM
replace doors and door casing shan2themax Carpentry and Woodworking 9 09-19-2008 10:07 PM