My bathroom vanity in an all in one which I think may be an epoxy casting. A small section of the sink surface has peeled off and I would appreciate learning if it can be fixed if it is epoxy and how to I do a repair. Thanks for your help.
If there a youtube video that shows that? Seeing makes it easier to understand. For DMX airflow tile is no problem because OSB is going over the underlay.
This might be much about nothing but 15 years ago I strapped my basement floor and lost probably 2 inches in the process. Now after a bathroom leak, I am at it again but no strapping for me. I want to know how to use a string or a straight edge to check the floor width to width along the entire...
DVR 33 RW Direct Vent fireplace insert
Worked flawlessly since 2012 when I purchased the home
Grandson placed blanket on hot glass and it melted onto the glass
I Removed glass for cleaning ( no luck so far) but did not disturb logs
After I reinstalled door the glass the pilot gave some...
Thanks for getting back to me I like Honeywell but I saw one post where they were saying the wiring instructions were incorrect ( probably not this unit) and thanks for the tagline "Our constitution was ......." applies to us here in the true North as well.
Are you saying I should have a pro...
Looking for help on how to install a humidifier for my furnace to address dryness that is causing my hardwood floor to gap. I was able to minimise the problem when I had a 50-gallon fish tank.
I want to install so that when the furnace comes on it activates or the blower is set to run when...
I traded in the old dishwasher for a Kitchen Aid Serial # FW4305915 and the results were dramatic. I got a quiet cycle with a fraction of the insulation and clean dishes and glasses to boot.
This was 4 months ago now the top rack is not delivering clean dishes , if there is chocolate or tea...
Just to clarify the line drop drops down form the ceiling at a 90 degree angle off the main line, that length is say 5 feet then it meets the shutoff and a union. Next there is a short elbow over to the gas heater.
My plan is to push the heater straight back about 28 inches which means the...
My hot water heater (gas) is located so that I cannot get by it to get to the rest of the room. To date we have been using a cut out in an adjacent room ( my office) which is now going to become a laundry room ( much better plan).
I am looking at 2 options , first I build a pocket door in the...
I need to create a neat entrance from my basement laundry room to the adjacent furnace room so that I can service my furnace periodically. There is a furnace door or opening but it is clocked off by the water heater.
How do I frame and install a 24 inch pocket door ?
Thanks
I saw a skylight in a new homes which resulted in an Internet search that introduced me to skytubes. In case I am not describing this product properly I am referring to an alternative involving a rigid or flexible reflective tube that is used to capture light and disperse it into a room. One...