While working on my furnace I checked my drain hose for blockages. The plastic manifold that the combustion fan mounts to was cracked and leaking moisture. I cleaned it up and sealed with JB weld. Does anyone know the actual name of this part. So I can replace it.
There is no circuit board on my model. I removed the old flame sensor and cleaned it. It worked fine for a couple days then started acting up again. Do you know what terminals I test across to check the valve?
I have a York stellar furnace (Model # p1udd12n07601a) and it will turn on the vent fan and the igniter the burners will light for a few seconds and then shut off . the vent fan continues to run, but then after 5 minutes the igniter starts glowing and it reignites. only to shut right back down...