Maybe. Since you say that..i would think if it is bad its in the mode..thinking the tubs full if water..stuck open or closed. I did just receive the manual so i can check that too. Thanks
Hi, Thank you all for your replies of support... Well its a Sears Kenmore Model 363.14074790,
I opened up the kick plate and gave the dishwasher a start up and was able to see the leaking. I have attached a picture. Looks like its dripping right out the bottom of what looks to be a motor / pump...
Just noticed leaking in the basement and i am 80% sure its the dish washer ..any idea where i can start? I assume by 1st pulling out of its cubby under the cabinet.
Thanks much!
Joe D.
Hi, Sorry for the delay....Crazy few days ! Anyway...I did buy a kit for this washer and it did not fix the problem...not getting what the deal is...
The Modle of my Kenmore 70 Series is 110.20702990.
Maybe If this dosn't help I can try taking a few digital pics and send those along ...
I will send along a model number.
Hard to explain this one.
The top part of the agitator comes apart and there is another housing part inside which has the cams in it. This part snaps onto 2 plastic tabs. Seems to snap in good but it doesn't stay. End up having to pop the top cap off and...
My agitator keeps popping off and i continually have to pop it back in.
Seems to clip in fairly good but obviously not.
I think it may be the slipperyness from the soaps or a design flaw.
I bought the agitator kit, which did not solve the issue.
Trying to find a solution.
Any suggestions...