Recent content by Spwquebec00

Thanks for the feedback. Apparently, Dewalt is not the only company with this issue..... Ryobi has many issues too. Input on brands such as Milwakee, Makita welcomed. I start to be suspicious that this could be an 8ndustry scam, designed very cleverly into the circuits to force consumers /...

Thanks for the input, and I tried your suggestion and various variations, but with no sucess. I have 5 chargers and I am going to strip one down to see if I can fool the circuit to just charge 20V. I will post any comments here for all, unless I get hurt in the pricess, then I shall sue Dewalt...

I discharged my 5.0 A/H 20v batteries until the green battery status light would not light. My charger is good and my battery is good, but because this chargeur is intelligent, for any of the 12V / 20V dual voltage systems, the measured voltage is too low for the charger to start charging for a...

Thanks, I`m going to go two foot past and treat, so there can be no questions when I close this back up. Gypse is easy once I`ve got the bad structure out and back in. An extra day of demo for peace of mind I think

Little could be foretold from a single lose tile in the bathroom.... until I took it off, expecting some damage. Well, there are reasons we take precautions against water damage I guess, but this single damaged tile and reliance on grout to stop water penetration, was foolhardy. Anyhow, the...