I have can lights installed in my ceilings. One of the can light comes on and then blinks and immediately goes out. I have replaced the bulb with new LED bulb but with same problem.
Do you think this is the problem with the fixture or the dimmer switch. The led bulb is dimmable.
I don't...
I have some rotating sprinkler heads on some of my Rainbird pop ups and they work fine. I installed them in places that would give me the coverage I needed. It is no trouble just pop the stems up and screw on the rotating nozzles and adjust them. They come with instructions on how to adjust...
Since you now know how to do this from the information in this post, call your contractor and tell them that you want the plastic under the unit. You should not have to do it yourself unless you were told before the contract was signed that they would not put the plastic under the unit. If...
As I promised, here is a picture of my lights at night. The only thing is you can't see what they really
look like because of the glare. This shows that it was a success.
Problem solved.
Problem solved and project finished.
The shipper sent me 120 volt bulbs instead of low voltage that I asked for. I just took for granted that they sent the correct voltage. I rewired the light to operate on 120 volts instead of through the landscape low
voltage transformer. That is not what...
I may have found the problem. I ordered 12 volt led bulbs and I think I was sent low wattage 120 volt bulbs.
I am going to take the low voltage 5 watt led bulbs out of the door lights and see if they work in the
non working light. I have also placed a call to super bright led lights.com to...
Here is what I was talking about SCREWS. They are the two brass and silver colored screw connections inside the socket.
I am attaching a picture attachment of the socket I am using and I am sure you will recognize them. They just don't have the pull down chain or the twist switch on them.
The low voltage transformer is a landscape auto timer that you can set to come on dusk to dawn or on and off at a scheduled time. It is just a low voltage transformer like everyone uses with outdoor landscape lighting. It is basically a timer that has a transformer inside it that cuts voltage...
The door lights work as they are suppose to. I will eliminate the switch but I do not see where that would
cause any problem just because when you turn off the switch it will just kill the juice going to the fruit jar lights and leave the door lights burning.
I will try this tomorrow by...
Don't know about your door as to what kind it is. My metal door has a pretty thick and expandable rubber strip on the bottom. The downward pressure can be adjusted to fit down tighter or looser. When you make it fit down tighter then it conforms to any spot that would be lower or higher than...