Search results

Hi everybody, I have 3 heating zones one of the zones is not getting heat for some reason. The oil burner kicks on when I turn on the thermostat but no heat. I did a little research and people were suggesting that it could be a zone control valve issue. I have checked and it does not seem...

Thanks for all the help it is greatly appreciated.

Ok Ill try that. Looks like most places have the vent close to standpipe but wouldn't it be more beneficial to be a little bit down the line more since some air is entering through the standpipe?

Was just looking at exactly that....appears that the vent should be close to the trap.

Did some measuring the first pipe is sloped 5 inches over 6ft then the next pipe is sloped 4 inches over just a little less than 6 ft. The whole thing starts 52 inches off the ground and ends inches off the ground. A cheater vent would just a be a straight vent sticking out somewhere along the...

I really don't know anything about plumbing so Im not sure where the stack is or if there is a stack. The drain pipe goes into the basement wall which is about 6-8 feet away but uses probably 10-12ft of pipe since it encompasses two walls. Somebody suggested that the trap was too deep so I cut...

Hi, My washer drain pipe keeps overflowing. I tried snaking it but a clog does not seem to be the problem. I think it may be the setup. If you look at the picture originally the standpipe was 9 inches (which was only slightly longer than the pipe leaving the trap) I thought this maybe be...