Search results

House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    gas stove, 2 burners won't lite

    If the electrode that is next to the burner is sparking when you turn on the burner check to make sure that the tip of it is clean. Can you supply the model number of your range? You can find the model number on the frame of the range where the drawer closes. If you need a new electrode...
  2. A

    over the counter microwave??

    As long as the air can circulate around the microwave it should work just fine. Some microwave are called space savers and are mounted on the bottom of the top cupboards. These type are not vented.
  3. A

    Opinions on Admiral brand

    Admiral has been around for years. More then likely made by Whirlpool. Just look on the model number tag it will have the manufacture on it.
  4. A

    fridge help

    If the fridge was low on freon it would not work properly so I don't think it needs to be charge unless you have a cooling issue also. Does it sound more like a vibrating noise? It could be age related.
  5. A

    Is my dishwasher dead?

    If the dishwasher start filling when it was off you will need a new fill valve. There should be a shut off valve under the sink to shut the water off to the dishwasher. A new valve for the dishwasher is 30 to 40 dollars. Remove the bottom panel of the dishwasher and you will see the...
  6. A

    Frigidaire electric stove element malfunction

    Even if your top does not lift up there should only be one screw holding the receptacle in place. A lot of the replacement receptacle come with Marr connector so you don't have to run the wire to the switch all you do is cut the wires to the old receptacle and use the Marr connect to join the...
  7. A

    Stove Racks

    If you still have not got a rack for your oven take the model number and call a local parts dealer or you can get your Appliance parts here. The model number should be on the frame of the range where the drawer closes.
  8. A

    Gas Stove needs a new gas tube for oven

    Hi Anevitte Does the schematic have any type of part number on it? Is the tube you are looking for Is it for the oven burner? Can you describe your range a little more? Is there a back splash with a light? Auntshe
  9. A

    Moldy water line in fridge

    If it is in the coil behind the crisper it can be replace.
  10. A

    Clothes Gas Dryer not heating

    Make sure you unplug the dryer before you do any testing. To check the igniter you will need an ohm meter. You should have a reading 50 and 500 ohms. You can also test the valve. On the three pin valve you should have the following readings: Between terminals 1 to 2 should read...
  11. A

    I everyone

    I everyone. I am an appliance service technician and like to help. I have been servicing for 23 years. I am looking forward to helping everyone I can.
Back
Top