I installed a new 200 amp underground service a couple years ago . It comes into the house at the opposite side of where the existing panel was . So I installed a new 200amp murray panel , then fed my existing panel with a 100 amp 3 wire and turned it into a subpanel.. All inspected .
Now this is where I ended that project. So I never a dressed the garage and out building , which are not wired properly as they are fed with a 2 wire , and not a 3wire. I'm want to adress this now , but my first question is .....
I'd like to remove the 100 amp wire and install a 200amp line to the second panel , but I don't see a 200amp breaker available . (Then I'll re use the 100 amp line for the garage ) . What's the proper way to feed 200amps from a main panel to a 200amp sub panel ?
Now this is where I ended that project. So I never a dressed the garage and out building , which are not wired properly as they are fed with a 2 wire , and not a 3wire. I'm want to adress this now , but my first question is .....
I'd like to remove the 100 amp wire and install a 200amp line to the second panel , but I don't see a 200amp breaker available . (Then I'll re use the 100 amp line for the garage ) . What's the proper way to feed 200amps from a main panel to a 200amp sub panel ?
Last edited: