PolyBatman
Active Member
- Joined
- May 26, 2014
- Messages
- 34
- Reaction score
- 4
Alright I have a few questions after finishing almost all the other work on my property about tiling my shower. I am using 12x24 inch tiles, ceramic, and I am not sure how to start the layout.
Here is the first image showing the general layout of the shower and how big the tile is compared to the half wall. The tile is just a tad shorter than the half wall and I am not sure if I should space it off the wall and fill with a tiny piece at the end or if I should split the tile and have a grout line?
Here is the half wall with the tile next to it. Again I am not sure how to have the layout since the tile is as long as the half wall and I don't think running whole tile all the way down would look good.
This is the uneven curb. After watching lots of videos I realized I could have just used hardie board and painted some of the waterproof stuff over it but I instead made a curb out of some mesh and lime concrete mix. I was wondering if I could trim the curb back flush with the half wall next to it?
Finally I have a piece of trim running around the door frame that hits the half wall. I haven't actually put it in place yet but was curious what might be a way I could end the tile next to this piece? I really appreciate the help and any ideas are welcome.
Here is the first image showing the general layout of the shower and how big the tile is compared to the half wall. The tile is just a tad shorter than the half wall and I am not sure if I should space it off the wall and fill with a tiny piece at the end or if I should split the tile and have a grout line?
Here is the half wall with the tile next to it. Again I am not sure how to have the layout since the tile is as long as the half wall and I don't think running whole tile all the way down would look good.
This is the uneven curb. After watching lots of videos I realized I could have just used hardie board and painted some of the waterproof stuff over it but I instead made a curb out of some mesh and lime concrete mix. I was wondering if I could trim the curb back flush with the half wall next to it?
Finally I have a piece of trim running around the door frame that hits the half wall. I haven't actually put it in place yet but was curious what might be a way I could end the tile next to this piece? I really appreciate the help and any ideas are welcome.