cdestuck
Well-Known Member
My friend has a greenhouse that I had put a 24” ventilation fan in. A single pole switch between the fan and breaker box, 20 amp breaker. So he bought this thermostat to automatically turn the fan for cooling when temps in 100 degrees.
So in the single pole switch 2x4 box, I’m planning to run a piece of nm wire from the box then into this thermostat. Before the sp switch I was going to take the black hot wire and tie it to the black wire of the nm going to the thermostat, and the white wire to the screw on the sp switch.
In the thermostat, I was going to attach the black wire to the “line in" screw and the white wire to the “Cooling”red wire terminal. Of course I know to put some black marker on the ends of the white wire. And the ground to the ground screw and grounded in the sp switch box. Is my thinking on this correct? Thanks to all.
So in the single pole switch 2x4 box, I’m planning to run a piece of nm wire from the box then into this thermostat. Before the sp switch I was going to take the black hot wire and tie it to the black wire of the nm going to the thermostat, and the white wire to the screw on the sp switch.
In the thermostat, I was going to attach the black wire to the “line in" screw and the white wire to the “Cooling”red wire terminal. Of course I know to put some black marker on the ends of the white wire. And the ground to the ground screw and grounded in the sp switch box. Is my thinking on this correct? Thanks to all.