Recent content by Jaz

For anyone to help, you'll need to tell us how the subfloor system is built. Is it built like a house or is there any gypcrete involved? Got any pics of how this level is built, perhaps of another area, not necessarily under your unit? How about some more info such as age, size, number of...

Drywall to floor spacing, ¾" or so. Jaz

I agree with the ⅛" between sheets, but have never seen any instructions that say ⅛" is good enough for perimeter gaps. I say minimum ¼". Jaz

Yup, and 3/32" notch is probably too much. * I have never made a mistake....I thought I did once....but I was wrong! :D You will learn to not ask those nice people anything that is too technical or requires experience. Jaz

If the vinyl is shiny on the back, I think you may have used the wrong adhesive. Read the container of adhesive again. It's sheet vinyl right? It's got a brand name and style/series name too. What size notch trowel did you use? Which is............? Jaz

You never said specifically what flooring you used. Vinyl, does not tell us much. We also need to know which adhesive you used and if the flooring was set into it right away, or if the adhesive was allowed to set or? Jaz

I disagree, I don't think it's the best way. You do not install glue-down sheet vinyl directly to ¾" underlayment. Most manufacturers tell you to install a proper ¼" instead. Among other reasons the ¼" will be much easier to remove when it's time. Loose lay or perimeter glued/stapled vinyls...

Fred, First decide what flooring you're gonna use and read their directions. I suggest you replace the particle board with ½" underlayment grade plywood then you'll be able to add the ¼" underlayment needed for the sheet vinyl. (not linoleum) You'll find ½" ply measures a bit thinner than...

I woulda removed some wood first which would have taken the floor down ¾" to the subfloor. Then I'd mud (sand cement) that area and continue the mud over the old brick making everything flat and level with the hardwood. I would remove about ¼" mud next to the hardwood and probably cut an...

Nelson, Your plan does not abide to the proper way to do the job on two levels. We do not install tile backer over concrete. We do not install tile backer over any plank or hardwood flooring. You made the job more difficult to finish correctly once you installed concrete over the...

I too am surprised the sales person didn't have you step on both choices to feel the difference. If you wanted softer, shoulda gone with 6 lb. It used to customary to use #6 on the main floors and #8 on steps. Jaz

Actually........the ideal way is to have the flange bottom on top of the finished flooring. However, if it's a little lower it'll still work. Just use a thicker wax ring or the shims as stated. Jaz

Well, got the right idea there Neal, but that's a stair nosing. Noob, you didn't supply enough info to give a good answer yet. You can start by giving your location cuz that may give us a clue on the methods used in your area. If the tiles are mortared direct to ply, we need to know the...

I was just wondering what type of CBU you used on the walls above the tub. Were you able to waterproof the walls, especially the window? Jaz

As Sam said, it's not a suggestion, it's a requirement. You mentioned wallboard around the tub. What's the finish covering going on these walls? Jaz