Recent content by Pcnerd

Looking at other brands then.

Time for a new one. Called support this morning. The circuit is 100, but they suggested I get complete new unit for warranty. :( Do you guys connect the power cord of the garage opener to a surge protector or just a standard outlet? We did have a few heavy rainy days in socal and some...

The wall control always have a red constant light lid up until tonight. That is what I am referring to, not the cover.

I did that earlier go bring the car in. Its too cold right now to reverse it. I check it out tomorrow. Its a IntelliG 1200 Genie (Professional line).

I have to check for the reset button. Right now car its inside blocking area.

Can one perform the installation alone? My current decided not to work today (after going home from work). Both light bulbs are not working. The on wall control doesn't have a lid on. Verified outlet to have power. I am thinking of buying the same manufacture brand (Genie). Thanks.

Probably looking at 7 ft height wall and a few more feet for the roof (Gable style). I want to keep it as simple as possible.

I inquired with city inspector and been told no permit required under 120 sq. ft.. I will build using normal wall/roof requirements.

If that high, I don't want to cut my current driveway slab to bury the block. I could probably have them sit on the slab and connect each with mortar and every 4 ft have a rod that goes down into the driveway slab.

Looking to start another project in the future. I want to build a 120 sq ft storage shed. 15x8 (haven't determined height yet but city allow 15 ft max on height. :)). I have a driveway behind the iron gate that goes 34.5 ft long x 12.5 ft wide. Planning the end of the driveway as a...

Tell him to take a hike. I went through that pain. Never!!!

We just did a room addition and the header was 6 ft wide and the beam used 6"x10" over a load bearing wall on a single jack stud. Engineer approved and city inspected. Snoonyb, I think you mentioned this as a better choice. I have used it before. I think you are correct. Since its not a...

Last question before the holidays. Are there any issue with running a power line on the same column (wall) as the water line? Want to put an outside light at that spot.

I had two accounts. One I forget I had for so long, :rofl:

I have two studs on each side, king and jack studs.