I have an older whirlpool clothes washer, the coupler between the motor and transmission broke into pieces and the washer wouldn't spin. I ordered another replacement coupler and replacing that wasn't much of a problem, the disassembly however was not so easy and I had to take the outer shell off of the drum because the motor face the wall of the housing making it impossible to remove the motor a bit to replace the coupler, ok so I assemble everything back in the order that I had removed it primarily wiring to take stress of the housing removal , now It won't fill water or nothing happens at all when I turn the dial for wash spin etc. I suspected lack of ground so I repeatedly tried to fasten the ground wire in better support and location with no results I also tired different working outlets to make sure power was going to the washer, don't know what I am overlooking or what I did to make the washer do nothing, need advise on what I could do to troubleshoot and repair this,Thanks.
Last edited: