Anil Cheerla
New Member
- Joined
- Jan 30, 2024
- Messages
- 1
- Reaction score
- 0
We are having issues with the GFCI outlet box that was installed as part of a new 20A circuit for lighting the underdeck. I have attached the photos that give a better picture than the explanation provided below.
The weatherproof 2-gang outlet box (pic 1) is full and it is accommodating a WR GFCI with four 12/2 wire runs inside. One run is for incoming power to GFCI and the other three are spliced inside and pigtailed to supply power to other runs. The other outlet box below (pic 2) has the has a switch and receptacle powered by the wire run from above to operate the under-deck lights.
You will notice 3 PVC pipes and another below for the 12/2 runs. Wires inside are in a clutter, squeezed in and the GFCI is tripping due to ground wires touching other wires. GFCI keeps tripping often and I decided to disconnect the power to this box from the main panel. I am now looking for alternatives to rearrange this box and reduce the clutter.
I am planning to separate the GFCI outlet from the box, relocate it to a new 1-gang PVC box above the current 2-gang box and repurpose the 2-gang box to locate the 3 incoming spliced wires and add a 20A receptable.
Is there a better way to reconnect the wire runs and GFCI? Can anyone recommend a better solution to this problem? This work was done by a contractor who is no longer available. Any help is very much appreciated.
The weatherproof 2-gang outlet box (pic 1) is full and it is accommodating a WR GFCI with four 12/2 wire runs inside. One run is for incoming power to GFCI and the other three are spliced inside and pigtailed to supply power to other runs. The other outlet box below (pic 2) has the has a switch and receptacle powered by the wire run from above to operate the under-deck lights.
You will notice 3 PVC pipes and another below for the 12/2 runs. Wires inside are in a clutter, squeezed in and the GFCI is tripping due to ground wires touching other wires. GFCI keeps tripping often and I decided to disconnect the power to this box from the main panel. I am now looking for alternatives to rearrange this box and reduce the clutter.
I am planning to separate the GFCI outlet from the box, relocate it to a new 1-gang PVC box above the current 2-gang box and repurpose the 2-gang box to locate the 3 incoming spliced wires and add a 20A receptable.
Is there a better way to reconnect the wire runs and GFCI? Can anyone recommend a better solution to this problem? This work was done by a contractor who is no longer available. Any help is very much appreciated.