Last edited:
Here's what it looks like after chipping away this morning. I can't find where its attached to the slab or drainpipe. Its in solid and its tilted at an angle.
The left side is just about flush with the floor and the right side is about half an inch below the existing floor. Do i knock it out somehow or use it as a base for a new flange like the one pictures which would be shimmed to level. If I knock it out I have to build the base up about an inch to reach floor level.
The old toilet was leaking from the bottom before we got rid of it. I'm guessing the wax ring was at fault. My next question is now that I've chiseled all the "custom" height adjustment, will where the flange is seated now going to be too low for the floor height. The high side of the tilted flange sits just at floor height. nealtw's drawings show the bottom of the flange at floor height.
Thanks
I replied before seeing your post snoonyb. Thanks for the update on what I have. Can I use this flange even though it sits at an angle?
Enter your email address to join: