It stopped getting stuck for a while but now it is getting stuck on Clean again. The question is whether it is the timer or control panel. I'd like to fix it so I don't have to keep restarting it using the breaker. Other than this the washer cleans the dishes just fine.
The blower motor was not running.
For the benefit of others experiencing the same problem, mine was a bad control board. Hard starting the blower motor proved it was not a fault with the blower motor. The board was not sending enough juice to the blower motor to run. Changing the board fixed...
The question is why is your unit reaching high limit. It doesn't necessarily mean it is the high limit switch. In my situation, my blower wasn't going on so it was triggering the high limit because the unit was working too hard.
My Fridgidaire dishwasher washes, dries, and then goes to "clean". All is fine until it reaches clean as it does not turn off. "Clean" is lit and the light does not go out unless I reset the circuit breaker. If I don't reset I can not use the dishwasher.
Dishwasher is not that old and was...
I replaced the filter this week. Is there only 1?
I had seen the 4 blinking lights and read on line that it was sometimes due to a dirty filter. Sure enough the filter was dirty so replaced it and the 4 flashing lights changed to a normal pattern. Still I did not get the forced air and then...
I though my problem had to do with the new thermostat I installed but have now realized that the thermostat is working fine. Heat is coming out of the vents however I now realized that no hot air is ever being forced out of the vents thus the house is never reaching the setpoint temperature.
I...
I am a new home owner. I have removed the old standard Trane thermostat and replaced it with a Honeywell Programmable Thermostat RTH8500D. I believe I connected it correctly but the inside temperature is not matching the set temperature. I know the heater is on and have seen the pilot lit. I...