Recent content by Rich55

Ok thanks Jeff

With a new swt. Should that solve my problem?

If I switch l1 to blk and l2 to red

Maybe I got the the red and black mixed up. Would that cause a short circuit?

The before wiring colours was an example. This is how I actually wired it. L red, p blue. H1 white h2 white and l2 black Thanks Richard

This is what I found.

It's the element on the bottom right that is broken now but the element on top right is the one I fixed. It's working as it should( top right) The bottom right element red indicator light is always on but is not warm nor hot to the touch. All I can think of is its a dead short to the right...

I match all the wires to its corresponding colours for example L1 white, P blue, H1 white with blk tape ( to distinguish between whites) H2 white L2 black. The new part # 318293810. I upload two picture of the original control swt. I don't know if this will help. Thanks Jeff Richard

Hey Jeff The model # C970 655821 Serial # NF 43212458 Thanks Richard

Model number is 1015398 from the back off the stove Thanks Richard

It is a kenmore. The small top burner but now the double burner does not work

I was installing a new control knob for one of the elements. I wrote down the pin outs with the matching wire color. I turned on the power switch the knob of the broken element , it started to spark and it tripped the Main 40 amp breaker. I took it part again to check for any black marks and...