Recent content by tepolt

I figured it out! There was a main power wire-white-that was burned out on the inside and not visible to the naked eye. when I traced the power that's where it stopped, so I did a through connection continuity test on the connector. While I was doing this the wire broke off the rest of the...

I just tried to run a normal cycle-it will not agitate either. I checked the motor coupler and it is fine. When I pulled the motor off I was able to turn the drive to the transmission and it did turn the tub when I moved it. Ted

Hello, I have a direct drive Whirlpool Washer Model GSX9885JT0 that will not spin. The last time it ran it went through all cycles and drained/spun out, however when the extra spin sycle was selected, it did not spin, you could just hear the drain solenoid activating-that was it. The...

Thanks for the tip!

Well, I found that the igniter and the sensor are one in the same and that the electrode was carbonized again. I cleaned for now to test-if this is it I may not replace it since there's only one more month or so of heating. Though if I need on, I see they go for around $21 on the web...

Hello All, This is my first post here. I am a Home Do-it-yourselfer-So be gentle... My 10-12 year old Carrier gas furnace (Model # 58ED 050131CA) has had an intermittent problem. It will blow warm air for a few minutes until house is up to the set thermostat temperature, then after the...