I purchased a flexible Downspout Connector (http://invisaflow.com/downspout-connector) to attach the end of an aluminum downspout elbow piece to a 4" PVC drainage pipe. Unfortunately the downspout Connector is too long to make the curve between the end of the elbow and the drainage pipe. I can't seem to find a similar product in a shorter length. Does anyone have any suggestions or alternatives? I measured from the mid point of the downspout elbow to the mid point in the drainage pipe and it is approximately 6.5 inches. I may end up either removing the gutter elbow, or the PVC elbow which should allow more room to install the downspout connector I purchased, just was looking for any other ideas...