Furnace Problem

Discussion in 'HVAC' started by akersmacker, Feb 16, 2013.

  1. Feb 16, 2013 #1

    akersmacker

    akersmacker

    akersmacker

    New Member

    Joined:
    Feb 16, 2013
    Messages:
    1
    Likes Received:
    0
    New igniter, new sensor, new control board...everything else works, but only get gas for about 2 seconds. Any ideas? Thank you.
     
  2. Feb 16, 2013 #2

    kok328

    kok328

    kok328

    Well-Known Member

    Joined:
    Nov 20, 2007
    Messages:
    2,755
    Likes Received:
    249
    Hopefully, you didn't replace these parts as part of a troubleshooting technique.
    Sounds like a mis-aligned flame sensor or bad gas valve.
    What make/model furnace is this?
     

Share This Page