Help with newly installed french doors

Discussion in 'Carpentry and Woodworking' started by wifeofjackofalltrades, Jul 1, 2010.

  1. Jul 1, 2010 #1

    wifeofjackofalltrades

    wifeofjackofalltrades

    wifeofjackofalltrades

    New Member

    Joined:
    Jul 1, 2010
    Messages:
    2
    Likes Received:
    0
    Hi, All! My husband just installed french doors with side lights. He was very careful measuring and re-measuring to make sure the frame was square and level and plumb. Now that the doors are installed they're sticking and one is higher than the other. He just can't figure out what to adjust next. It seems to get worse. Thanks!
     
  2. Jul 5, 2010 #2

    bigjude

    bigjude

    bigjude

    New Member

    Joined:
    Jul 5, 2010
    Messages:
    4
    Likes Received:
    0
    check to make sure the hinges are screwed in tight. then open the doors and check one at a time in the closed position to make sure they are plumb. make sure the base is level with support along the entire bottom of the door. Recheck plumb and level, not just against the frame but at the hinges as well. Measure the top and the bottom of the frame.
    When screwing the frame to the wall framing make sure the shims are in tight, if it sucks in when you tighten down on the screw that will throw all the plumb out of whack. If your doors are uneven something is not plumb somewhere. If the doors are sticking/dragging/rubbing the top make sure it is level all the way across the opening it may have a bow at the top in which case you would need to shim it to the correct position and drive a screw there.
    If you need further assistance just let me know you can email me at jude@finelineconstruction.biz
     
  3. Jul 5, 2010 #3

    wifeofjackofalltrades

    wifeofjackofalltrades

    wifeofjackofalltrades

    New Member

    Joined:
    Jul 1, 2010
    Messages:
    2
    Likes Received:
    0
    Thanks so much for your thorough answer! Since my post he did pretty much what you described and now it seems to be good.
     
  4. Jul 5, 2010 #4

    bigjude

    bigjude

    bigjude

    New Member

    Joined:
    Jul 5, 2010
    Messages:
    4
    Likes Received:
    0
    seems an atta boy and a pat on the back is in order. LOL
     

Share This Page