Problem with vessel faucet

Discussion in 'General Home Improvement Discussion' started by CENTENNIAL, Jul 2, 2007.

  1. Jul 2, 2007 #1

    CENTENNIAL

    CENTENNIAL

    CENTENNIAL

    New Member

    Joined:
    Jul 2, 2007
    Messages:
    1
    Likes Received:
    0
    We are redoing our guest bathroom and bought a vessel ink, a waterfall faucet, and a vanity with a granite top with 2 pre-drilled holes in the vanity top. Ran into a problem, though. The waterfall faucet is slightly angled and we are not able to install it because the pre-drilled hole for the faucet is apparently too close to the sink. If my faucet sat about an inch higher or the curve started a bit further up, then we could have installed it, but right now it will not fit. Is there anthing we can do? Some kind of extender for the faucet, maybe? Or a mounting ring similar to the one the vessl sits on? Helppppppp!!!!!!!!!!!
     
  2. Sep 10, 2007 #2

    Benmo Design

    Benmo Design

    Benmo Design

    New Member

    Joined:
    Sep 10, 2007
    Messages:
    3
    Likes Received:
    0

Share This Page