tomsmyth
Junior Member
- Joined
- Nov 15, 2010
- Messages
- 8
- Reaction score
- 0
Hi folks. I just finished replacing a desk lamp turn switch with one of these:
http://www.ebay.com/itm/261366459744?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
Just want to make sure I'm not doing anything unsafe.
Here is how I wired it up:
Then I put on some electric tape:
These things came off the old switch, I'm assuming they're like electric tape? I didn't put them back on because they're in such bad shape:
I couldn't get the wire clamp back on where the wire goes into the housing, but there is a rigid connection below and it doesn't move much so I'm thinking I'm ok:
How did I do? Thanks for looking!
http://www.ebay.com/itm/261366459744?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
Just want to make sure I'm not doing anything unsafe.
Here is how I wired it up:
Then I put on some electric tape:
These things came off the old switch, I'm assuming they're like electric tape? I didn't put them back on because they're in such bad shape:
I couldn't get the wire clamp back on where the wire goes into the housing, but there is a rigid connection below and it doesn't move much so I'm thinking I'm ok:
How did I do? Thanks for looking!