farmerjohn1324
Well-Known Member
- Joined
- Aug 5, 2016
- Messages
- 963
- Reaction score
- 103
Is there a way to put plywood in front of the cabinet where the door is and have it not look bad?
Also, had a tub leak. Any idea how to patch all this floor?
Also, I have a 6" x 6" hole in plywood floor in other part of trailer. It's in a corner with nothing to attach to on 2 sides. How do I patch that? I could get a picture tomorrow.
You should cut the floor and find the joist for support and repair from their.
Leave it open and when you advertise it for rent, put some small artificial flowers in the space, and if it's mentioned, tell them it's left open to display decorative glassware.
What about the drawer in the bathroom?
Any hrdw. vendor will have decorative vinyl trim for around the tub.
The floor looks place-n-press tile so just clean it up and either add more or replace it all.
There's no joists in the corner.
I'm talking about replacing the bits of soggy plywood I had to rip out. It's next to a wall, so nothing to support it with.
If I don't put something down here (red), I have nothing to stick the tile to.
You'll need to crawl under there and find the support mechanism and work from there.
Change all of them to the same new material, so nothing to match, but all the same.
Then do the same thing cabinet vendors have been doing for years, cut a piece of paneling and fit it into the recess in the doors.
Enter your email address to join: