Front porch repair!

Discussion in 'Carpentry and Woodworking' started by KFlynn, Sep 12, 2010.

  1. Sep 12, 2010 #1

    KFlynn

    KFlynn

    KFlynn

    New Member

    Joined:
    Sep 12, 2010
    Messages:
    2
    Likes Received:
    0
    Hi!
    I have an old home built in the late 1800s.
    I have a wooden porch that is in great condition except for one board at the top of the porch that is starting to rot just a little bit at the very tip.
    Structurally it's in great shape, but I was wondering if anyone had any tips on repairing it.

    Tried some plastic wood and it didn't seem to work. Just crumbled off a couple weeks later.

    I don't have a lot of experience in dealing with this type of thing and am hoping to not replace any of the boards at this time. I just want to fix it cosmetically for now.

    Any tips would be greatly appreciated!

    Thanks!!!!!
     
  2. Sep 13, 2010 #2

    Nestor_Kelebay

    Nestor_Kelebay

    Nestor_Kelebay

    Emperor Penguin

    Joined:
    Mar 29, 2009
    Messages:
    1,844
    Likes Received:
    2
    I'd allow time for that wood to dry out, and then scrape off any soft wood.

    Then, repair that wood with epoxy.

    [​IMG]

    The above is a wood repair kit you can buy for about $15 at Lee Valley. However, you should be able to buy the components anywhere they sell epoxies.

    The two bottles contain a liquid epoxy and hardener. You mix equal quantities of both to make an epoxy that will penetrate into your wood. It has about an hour working time.

    Then, you mix equal quantities of the paste resin and hardener in the two tubs. You then use that to "rebuild" the missing wood. It dries to a tan colour similar to wood.

    Ideally, you want to apply the paste epoxy to the wood when it's still damp with liquid epoxy so that the two epoxies will crosslink with each other for a stronger bond.

    And, you can also mix the paste epoxy with the liquid epoxy (after mixing each up separately) to make a "mud" similar to joint compound that you can spread with a putty knife.

    Then allow time to cure. Prime, paint.
     
    Last edited: Sep 13, 2010
  3. Sep 13, 2010 #3

    KFlynn

    KFlynn

    KFlynn

    New Member

    Joined:
    Sep 12, 2010
    Messages:
    2
    Likes Received:
    0
    Hey Nestor... Thanks a bunch! I will try this! Much appreciated!
     

Share This Page