Garage door reverses

Discussion in 'General Home Improvement Discussion' started by Squeeker, Oct 26, 2006.

  1. Oct 26, 2006 #1

    Squeeker

    Squeeker

    Squeeker

    New Member

    Joined:
    Oct 26, 2006
    Messages:
    1
    Likes Received:
    0
    Hey guys...I have a wooden garage door with a Sears opener on it. A few weeks ago i had one of the springs break. I replaced both with a matching set. Now when you press the button to close it. It will go almost all the way down and then reverse automatically, as if it would hit something. I have tried adjusting the downpressure switch to no avail. If you hold the interior button and release it when the door is all the way down there is no problem. Is there a way to bypass the safety switch? I realize this is not a correct repair, but I live in a rural area, no kids, pets etc. and it would be OK here! Any help would be greatly appreciated. thanks in advance!:D
     
  2. Oct 26, 2006 #2

    CraigFL

    CraigFL

    CraigFL

    Well-Known Member

    Joined:
    Mar 13, 2006
    Messages:
    409
    Likes Received:
    0
    It sounds like you have a door with two extension sprngs -- one on each side? The ones you bought may not be matched closely causing the door to cock on the way down and jam causing ther overload to trip and raise the door(safety feature against blockage). If you have a spring scale(fish scale will work), you may want to check the extension force for a given extended length to be sure.

    If the spring is a match to the other one, you need to be sure that they are both extended equally when the door is closed. This will give approximately the same force. You will need to adjust the cable length so this happens.

    Although you shouldn't bypass the safety feature, there is usually an adjustment for the trip force on the opener. You instructions should show you how to do this.
     
  3. Oct 26, 2006 #3

    Quattro

    Quattro

    Quattro

    Massive Tool Belt

    Joined:
    Oct 10, 2006
    Messages:
    262
    Likes Received:
    0
    Yup, there should be a screw somewhere on the unit that you can adjust. This will allow more or less force applied against the movement of the door to cause the opener to reverse.
     

Share This Page