I put some vinyl flooring on the landing and stairs. After a few days the part on the treads (2x10 lumber) started to bubble up. On the landing that was covered with a piece of finished plywood it is fine. Also on the risers that are chip-board it did not bubble, it's not really stuck, but did not bubble.
I took off one of the nose caps and the flooring just lifts right up, the glue is not dry at all. I left it the recommended time after application before putting the flooring down.
Any ideas what happened here and if there is any way to fix it besides lifting all the flooring and cleaning the glue off and starting over?
I took off one of the nose caps and the flooring just lifts right up, the glue is not dry at all. I left it the recommended time after application before putting the flooring down.
Any ideas what happened here and if there is any way to fix it besides lifting all the flooring and cleaning the glue off and starting over?