I have a basement/workbench area. Its about 30 to 40 feet long by about 20 feet wide withshelves at the sides. There are two edison sockets for normal bulbs there. I would like the replace those two edison sockets with three or four fluorescent T5 (T8?), thereby improving the light for the whole area including the workbench. Putting them where the sockets currently are should be trivial. I have hard wired stuff before in my kitchen with breautiful results. What about the others? Could I just take a wire fromone fixture, twist it on the other wires, cap the connection, and run it to the next; in parallel? Or is that bad practice? I'm guessing it would be trivial. Twist white to white, black to black and green to green.