Spalling Concrete

Discussion in 'Bricks, Masonry and Concrete' started by doechsli, Jun 20, 2012.

  1. Jun 20, 2012 #1

    doechsli

    doechsli

    doechsli

    Well-Known Member

    Joined:
    May 29, 2012
    Messages:
    68
    Likes Received:
    23
    My home is about 55 years old and has poured concrete basement walls. Along the bottom two feet in several spots, the concrete is "peeling" although very slowly. I don't have water getting into the basement and I really don't think there is much moisture pressing on the outside of the walls. Is there a way to permanently fix this?
    :help:
     
  2. Jun 21, 2012 #2

    BridgeMan

    BridgeMan

    BridgeMan

    Well-Known Member

    Joined:
    Aug 11, 2011
    Messages:
    744
    Likes Received:
    80
    Without seeing pictures of the actual damage, it's difficult to suggest a solution to your problem. Probable cause was the water-cement ratio being too high in the fresh concrete when it was placed. Could be the result of some isolated accumulations of water in the bottom of the forms (on top of the footings), which would tend to be displaced upward along the form surfaces by the denser concrete. If the entire operation was done with concrete having been too wet, you'd tend to see surface deterioration everywhere, not just at the bottoms of the walls.
     

Share This Page