Sub floor in upstairs bathroom

Discussion in 'Flooring' started by Sweetslice, Aug 14, 2013.

  1. Aug 14, 2013 #1

    Sweetslice

    Sweetslice

    Sweetslice

    Member

    Joined:
    Aug 6, 2013
    Messages:
    6
    Likes Received:
    0
    Good morning!

    I thought I had my answer per another post but just to be the same answers apply to an upstairs bathroom....

    We had to tear out the plywood flooring in our upstairs bathroom to get rid of mold (treated and all that, mold = gone!). He took out two full sheets of plywood and replaced with 3/4 inch treated sheets. The existing plywood, still healthy, measured 3/4 inch, there's only a small strip on the far end of the bathroom left.

    These were attached to braced beams below.

    Naturally, the new plywood is probably 1/8 to 1/4 inch thicker. We plan to put down cement board and ceramic tile.

    In a prior post, it was suggested to level plywood difference with a cementious based floor patch / leveler. Is this still the product and method to use in our case?

    Thank you. If anyone has questions about creating a publication for print, I can help with that. :rolleyes:
     
    Last edited: Aug 14, 2013
  2. Aug 14, 2013 #2

    Drywallinfo

    Drywallinfo

    Drywallinfo

    Well-Known Member

    Joined:
    May 21, 2013
    Messages:
    152
    Likes Received:
    36
    Sounds like the floor leveler is your best bet.

    I have used thinset to fill in gouged out spots in plywood after removing vinyl and that worked as well since I was using that very same thinset for my durock that was under my tile. If your strip is very small the thinset would probably work fine if you will be putting down durock or some other cement board under your tile.
     
    nealtw likes this.

Share This Page