I've noticed an inssue in my workshop over the last week. It is a seperate building from the main house and has it's own sub-panel.
My heavier draw 110v tools (i.e. table saw, bench sander, shop vac, etc) are running a lot slow than normal. The table saw barely gets up to speed. The shop vac audibly slows down when the bench sander is started. GFI's trip for no reason. Nothing new has been added to the shop. FYI, the 220v circuit seems fine (my 220v compressor starts and runs OK).
Is this within the DiYer to troubleshoot or is it time to call an electrician? I have a good voltmeter but I'm not sure where to start.
Thanks
Curt
My heavier draw 110v tools (i.e. table saw, bench sander, shop vac, etc) are running a lot slow than normal. The table saw barely gets up to speed. The shop vac audibly slows down when the bench sander is started. GFI's trip for no reason. Nothing new has been added to the shop. FYI, the 220v circuit seems fine (my 220v compressor starts and runs OK).
Is this within the DiYer to troubleshoot or is it time to call an electrician? I have a good voltmeter but I'm not sure where to start.
Thanks
Curt