Window Sill repair / Replace PVC

Discussion in 'Windows and Doors' started by JRV, Sep 26, 2010.

  1. Sep 26, 2010 #1

    JRV

    JRV

    JRV

    New Member

    Joined:
    Sep 26, 2010
    Messages:
    1
    Likes Received:
    0
    Any assistance you may provide with “how to” information with regard to the use of PVC window sill products would be appreciated.

    The project I am working on involves replacement (full or partial), depending on the condition of the existing wood sill, of wood window sills using PVC products. The repair / replacement work of existing sills is to be completed prior to the installation of replacement windows.

    In addition to information on full sill replacement identifying a repair process that calls for cutting / preparing the existing wood sill to receive a PVC sill nosing (partial sill replacement) is very important to the success of the project.

    Thank you for any assistance you may provide.
     
  2. Dec 3, 2010 #2

    SillMaster

    SillMaster

    SillMaster

    New Member

    Joined:
    Dec 3, 2010
    Messages:
    2
    Likes Received:
    0
    Hello,

    You might take a look @ Sill Masters - Premium Quality Vinyl Window Sills for solid vinyl window sills. You can also cut these and use them for jamb extensions and/or casing around any moisture areas like basements, shower windows or kitchen windows
     
  3. Jan 10, 2011 #3

    joecaption

    joecaption

    joecaption

    Well-Known Member

    Joined:
    Jan 8, 2011
    Messages:
    2,043
    Likes Received:
    293
    Most often it's faster and no more expencive to just replace the whole window.
     
  4. Jan 14, 2011 #4

    Tangelo

    Tangelo

    Tangelo

    Member

    Joined:
    Sep 13, 2010
    Messages:
    19
    Likes Received:
    0
    Hello JRV, here are the steps to replacing your window sill. If you haven't found the Vinyl Sill & Nosing you can go to any Lumber yard, that's where I got mine> http://tinyurl.com/4lrkgpf

    [​IMG] [​IMG]




    1. Raise the sash and remove the top plate. Pry away as much material as you can. Use the reciprocating saw to cut through solid material and clear it away.

    2. Pry out the main part of the sill. Try to keep it as a whole piece for use as a template for cutting a replacement.

    3. Use the folding rule to get inside measurements to cut a new top plate.

    4. Place the old sill on a 2-by-6 and trace around the edge to mark cut lines. While you're at it, mark the measurements for the top plate on a 1-by-6.

    5. Wearing a dust mask and safety glasses, cut the new pieces with a table saw.

    6. Slide the new sill into place, and then pry away interior trim and slide the top plate into position. Drive galvanized screws down through both pieces and into studs below. Secure the bottom sill by driving screws through the outside edge.

    7. Run a bead of caulk along the edge to seal any gaps. Reattach trim pieces if necessary.
     

Share This Page