Cold air return?

Discussion in 'General Home Improvement Discussion' started by magicr, Mar 13, 2010.

  1. Mar 13, 2010 #1

    magicr

    magicr

    magicr

    New Member

    Joined:
    Mar 13, 2010
    Messages:
    1
    Likes Received:
    0
    I built an office attached to my garage but not connected to my living space in my house. I tapped into my familyroom heating ductwork, (which had two vents and was always the hottest part of house in winter and coolest part in summer) and ran insulated flexible duct work to my office. When the door is opened from my office to the garage just a crack, and the heat is on it blows great, but when everything is shut up, it barely comes out. I realize that I have no cold air return in this isolated room, and am curious as to how I tap into the existing cold air return system. Are there certain fittings that I can use, do I cut into return at a certain place? My return system vent for the house is placed in my hallway in the ceiling. My house is single story.

    Hope this makes sense. Thanks
     
  2. Mar 13, 2010 #2

    travelover

    travelover

    travelover

    Well-Known Member

    Joined:
    Aug 5, 2007
    Messages:
    693
    Likes Received:
    2
    You need to look at your cold air return ducting and see where you might tap into it. On some houses, the space between floor joists is closed off and used as a cold air return. You might have a similar opportunity.
     

Share This Page