GE Profile comprerssor start and run terminal locations.

Discussion in 'General Appliance Discussion' started by RobertH59, Nov 5, 2010.

  1. Nov 5, 2010 #1

    RobertH59

    RobertH59

    RobertH59

    New Member

    Joined:
    Nov 5, 2010
    Messages:
    1
    Likes Received:
    0
    compressor start and run terminals location.
     
    Last edited: Nov 5, 2010
  2. Nov 6, 2010 #2

    woodchuck

    woodchuck

    woodchuck

    Well-Known Member

    Joined:
    Jul 19, 2008
    Messages:
    272
    Likes Received:
    26
    Depending on the model it either plugs into the compressor or is in line with the wires before they go into the compressor. The relay is a small usually black cube shaped electrical part plugged into the compressor or wired to it nearby. It may appear burnt or rattle when shaken if it's bad. The two connections should show continuity with an amp meter.
     

Share This Page