I've had an issue lately with my doorbell not working. I checked the transformer in the breaker box, and have power to it, and I also have power at the Ring doorbell itself. In the doorbell box, I have two low voltage wires, each with a red and white wire. Out of those wires, a red and white from each of them are tied together, and a red from one and a white from the other are going to terminals on the plungers. If I test the terminals, I have no power. But, If I put a probe on the red/ white that are tied together, and the other probe on either terminal, I have power. I'm not sure what the issue is?
I've not done any changes to anything recently, so nothings been moved or disconnected. It just stopped working.
So I have no power here-
I've not done any changes to anything recently, so nothings been moved or disconnected. It just stopped working.
So I have no power here-