Neither did I...Hmm?I didn't realize we were talking about an electric heater with A/C...
Power on to air handler...kok328 said:Turn on power to the air handler and see if it is flashing diagnostics codes.
I do not see a switch on the door, as you describe.Does this unit have a switch on the door and has it been checked?
I do not see a switch on the door, as you describe.
FWIW, the wiring diagram is available here in PDF.
Thanks!Just a hopeful shot in the dark.
Thanks!
Hoping someone more knowledgeable than I might be able to look further at the wiring diagram to see if there are provisions for a panel or door safety switch.
Great, thanks!Did not see a door switch in the wiring diagram .
Can not remember the correct name , but the diagram looks like this may be a variable speed motor ?
God bless
Wyr
Here's a pic of wiring diagram for ez viewing:the unit has a X-13 constant torque motor which is tricky for some Pros and hard for a DIYer to troubleshoot... It uses a low voltage signal from the circuit board to energize the motor. Has no capacitor and is not a PSC motor. You need a flow chart and some electrical experience and test meter and to follow the chart steps to check it, not easy to do over the net.
Thanks!
Labelled where?So the connections should be labeled for you to figure out which to pull out and check
Labelled where?
Thanks!this will help understand some of the wiring but right at the end he talks about a flood switch that turns everything off if the water isn't draining
https://www.youtube.com/watch?v=pCgPskm9aHs
That would be easy to bypass to prove it isn't a problem.
Neal, where are we with this one?
What's not working and what has been tested?
Enter your email address to join: