So, took it upon myself to pull permits to install a new service mast, meter socket, main breaker panel and all the while also subpaneling the existing fusebox. Main reason is because I want to install a generator to keep power going during outages for a data rack I installed in my detached shop that will host business applications for my IT outsourcing company. We lose power for about 30 days out of the year, usually 7-14 days consecutively.
The old service entrance is shotty at best. I pulled permits and nothing in this house is permitted and records show it was built in 1926. All the interior wiring is ungrounded, only neutral and hot wires on branch circuits.
Theres double taps on the range fuse (top right).
So thats the old, here is the new thus far:
The plan is to run the conduit across the wall to where the meter socket is (The top LR has reduction bushings stepping down from 2" to 1-1/2" to 1-1/4". Once its through the wall Ill do some fancy conduit work to make the connection in the existing fusebox.
The EMT between the meter and breaker is long because I am planning to install a generator and a whole-house ATS will go in that spot when I purchase the equipment later down the road.
Couple questions.
Any input? Guidance? Criticisms and corrections?
Once this is basically ready to go, do I disconnect power, subpanel the fusebox and call in the inspection, once its passed call the PoCo for reconnection? I have two inspections on the permit, service and final. Just need clarification so I can coordinate the install with minimal electrical interruption.
Guying.... These are odd.... Any advice on installing them? The PoCo (Pacific Power) specs say the guys need to be 16-24" apart, but ive seen a few that are further apart. Also, with the roof slope one wire will likely be longer than the other to ensure the angle of the wire to mast is at least 45 degrees....
Thank you! Cant wait to hear from you all!
The old service entrance is shotty at best. I pulled permits and nothing in this house is permitted and records show it was built in 1926. All the interior wiring is ungrounded, only neutral and hot wires on branch circuits.
Theres double taps on the range fuse (top right).
So thats the old, here is the new thus far:
The plan is to run the conduit across the wall to where the meter socket is (The top LR has reduction bushings stepping down from 2" to 1-1/2" to 1-1/4". Once its through the wall Ill do some fancy conduit work to make the connection in the existing fusebox.
The EMT between the meter and breaker is long because I am planning to install a generator and a whole-house ATS will go in that spot when I purchase the equipment later down the road.
Couple questions.
Any input? Guidance? Criticisms and corrections?
Once this is basically ready to go, do I disconnect power, subpanel the fusebox and call in the inspection, once its passed call the PoCo for reconnection? I have two inspections on the permit, service and final. Just need clarification so I can coordinate the install with minimal electrical interruption.
Guying.... These are odd.... Any advice on installing them? The PoCo (Pacific Power) specs say the guys need to be 16-24" apart, but ive seen a few that are further apart. Also, with the roof slope one wire will likely be longer than the other to ensure the angle of the wire to mast is at least 45 degrees....
Thank you! Cant wait to hear from you all!