floor vent for wood stove

Discussion in 'HVAC' started by squig, May 29, 2007.

  1. May 29, 2007 #1

    squig

    squig

    squig

    New Member

    Joined:
    May 29, 2007
    Messages:
    3
    Likes Received:
    0
    My husband wants to install a floor vent in our upstairs hallway so the hot air from the woodstove in the family room can heat our bedrooms. has anyone done this? What would we need, and where would we get it? Anybody know if this is against some kind of fire code?
    Thanks - Sue
     
  2. May 29, 2007 #2

    glennjanie

    glennjanie

    glennjanie

    Well-Known Member

    Joined:
    Mar 1, 2006
    Messages:
    2,990
    Likes Received:
    4
    Welcome Sue:
    My Dad's first cousin was Sue Quig; small world.
    You need to check with the local fire department or building inspector for the Code answer. However, I have seen this done in several instances and it worked just fine. A ceiling fan blowing upward on low will help to circulate the air in your home too.
    You could use a return air grille on the ceiling and a floor register above to finish it off. Maybe it would be best to buy the grille and register before cutting the hole. If your joists are on the standard 16" o.c. spacing you can only use up to a 14" register between them but the length can be 24" or more. Remember, you are depending on gravity flow to move the heat up (hot air rises, cold air falls) it would be a good idea to leave any doors open between the two spaces for free movement.
    Glenn
     
  3. Jun 1, 2007 #3

    squig

    squig

    squig

    New Member

    Joined:
    May 29, 2007
    Messages:
    3
    Likes Received:
    0
    thanks glenn
     
  4. Apr 14, 2008 #4

    Netta1989

    Netta1989

    Netta1989

    New Member

    Joined:
    Apr 14, 2008
    Messages:
    1
    Likes Received:
    0
    OK, I am searching for some helpful tips. I have a rancher house with a wood stove in the basement, I also have a gas fireplace on the first floor almost right above my wood stove. I am trying to find a way to vent my floor or walls to have the heat rise to my main level floor to help with heating cost. We leave the basement door open the heat does rise up the steps but it's really only heating the kitchen that is right at the open door. We can feel a difference through the floor but I am looking for something more effective and money saving. I have a few ideas, wonder if any suggestions? I am looking to see if I can replace my drop ceiling tiles for a "open" grid like for my ceiling tiles? Also, I have been thinking about putting "vent" through the floor on both sides of my fire place to help bring "more" heat to the main level. Another idea I had was maybe making "vents" in my walls on my main level somthing like ducts to have the heat move quicker to the main level? Any ideas? Thanks in advance
     
  5. Apr 14, 2008 #5

    guyod

    guyod

    guyod

    Senior Member

    Joined:
    Jan 12, 2008
    Messages:
    423
    Likes Received:
    21
    Sounds like you have all good ideas.

    Do you have forced air? i have seen homes where they rigged the duct work to circluated wood fire place heat through the ducts.

    An exhaust fan in your drop ceiling pulling hot air into your first floor would help alot too. If you get a thermostat controlled on it will turn on only when there is hot air to move.

    I would have one opening in the ceiling above the fire place . Use the grill you are talking about then have the fan above that and put floor vents in where needed. the whole area above the drop ceiling will be a big heat duct.

    good luck
     
  6. Apr 14, 2008 #6

    handyguys

    handyguys

    handyguys

    Well-Known Member

    Joined:
    Feb 22, 2008
    Messages:
    815
    Likes Received:
    2
    glennjanie has it - I have done this in a cottage heated with just a single propane heater on the first floor. The bedroom above has a floor register and is open to below (no ceiling, exposed beams). If you have a finished ceiling then a grill on that side would finish it off. I am not aware of any code issues with doing this.
     
  7. Apr 15, 2008 #7

    inspectorD

    inspectorD

    inspectorD

    Housebroken Staff Member Admin Moderator

    Joined:
    Dec 17, 2005
    Messages:
    4,502
    Likes Received:
    267
    Those are good ideas, just remember not to vent up through at the gas fireplace. The wrmaed up air will just go up the flue of the fireplace as makup air.
    Move the vents about 10 feet from the area above the fireplace. the heat will find it's way up.:)
     
  8. Apr 29, 2008 #8

    jasonkoll

    jasonkoll

    jasonkoll

    Member

    Joined:
    Mar 31, 2008
    Messages:
    5
    Likes Received:
    0
    It is by no means a bad idea, as hot air natrually rises and cold air natrually drops. How well does it travel up the stairway now? Cutting in a few return air ports is not going to increase the travel substaintally.
     
  9. Nov 20, 2008 #9

    Firefita88

    Firefita88

    Firefita88

    New Member

    Joined:
    Nov 20, 2008
    Messages:
    1
    Likes Received:
    0
    I'm not sure if anyone is still reading this thread, but I have been looking to do the same thing as stated in the original post. I have a 12x24 living room on the first floor, and the exact same size room above it on the second floor. I want to heat the second floor living room with the heat from the wood stove on the first floor. Also, the first floor living room becomes too hot and almost unbearable (90 degrees when the stove is cranking).
    I also wish to place some vents in the ceiling (plaster) to the floor above (hardwood). I did find out that IF YOU ARE GOING TO DO THIS, you must use ductwork. Simply put a sheet metal duct connecting the vent in the ceiling to the register in the floor above. The reason for this is if there is ever a fire in the home, this will prevent the fire from spreading through your floors. If you do use ductwork, once fire reaches the ceiling vent it will make its way in and down the joists. Once the fire gets between your ceiling and the floor above it - it will certainly make its way through the house in no time and makes it very difficult for firefighters to extinguish.
    They also sell register vent fans to help assist with air flow if need be. I did a google search under "register fan" and many came up. Hope this helps....
     
  10. Aug 26, 2013 #10

    judester

    judester

    judester

    New Member

    Joined:
    Aug 26, 2013
    Messages:
    3
    Likes Received:
    0
    I have a 1/2 wood - 1/2 oil furnace - we use mainly the wood portion as we like it nice and hot in the winter.
    The heat from both sections of furnace goes up through all the floor vents in the house but we are finding the
    heat from the wood gives off a lot of residue on the windows, curtains and walls. Hate to think what we are
    breathing. Does anyone have a solution to stop the black film going on everything? Is there some kind of
    insert we could put in the floor vents for the film without blocking the heat into the room?
     
  11. Oct 6, 2013 #11

    coachgeo

    coachgeo

    coachgeo

    Remodelling

    Joined:
    Sep 21, 2013
    Messages:
    49
    Likes Received:
    4
    sounds like inefficient chimney draft on the wood stove allowing for smoke to get into the room. How long has it been since you cleaned the chimney?
     

Share This Page